Yes!
By default, the EmotiBit firmware configures the PPG sensor to capture data at 25Hz. If you want a higher sampling frequency, check out the official 100Hz firmware variant that increases the PPG sampling rate to 100Hz!
You can grab the firmware variant on our official release page and use the EmotiBit Firmware Installer to upload that firmware to the EmotiBit. See our documentation to find steps to install custom firmware.
NOTE: Please be careful when downloading the firmware variant and choose the firmware created for your Feather type (Feather M0 or Feather ESP32).
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article